Tradesman DP12LW, Руководство пользователя

Страница: 12 / 22

ASSEMBLY
6. Unlock the table support lock (4 – Fig. 4) and swing the table
away from the bottom of the chuck. Lock the table support
lock.
7. Using a mallet or a hammer and a block of wood, tap the
chuck up firmly (Fig. 11).
Fig. 11
MOUNTING DRILL PRESS TO WORK SURFACE
(FIG. 12)
1. If mounting the drill press to a workbench, a solid wood
bench is preferred over a plywood board, to reduce noise
and vibration.
2. Holes should be pre-drilled through the supporting surface.
3. The hardware to mount this drill press is NOT supplied
with the tool. The hardware as shown in the illustration
should be used:
Fig. 12
1. Drill press base
2. Bolt
3. Flat washer
4. Rubber washer
5. Worksurface
6. Flatwasher
7. Lockwasher
8. Hex nut
9. Jam nut
12