Tradesman 53433, Руководство пользователя

Страница: 22 / 30

MITER CUTS
This cutting operation is the same as crosscutting except the
mitre gauge is locked at an angle other than 90
o
.
1. Set the miter gauge to the desired angle (see Fig. 27).
2. Hold the workpiece (2) firmly against the miter gauge (3).
3. Feed the workpiece slowly into the blade (1) to prevent the
workpiece from shifting.
COMPOUND MITER CROSSCUTTING
This cutting operation combines a miter angle with a bevel
angle.
1. Set the blade (1) bevel to the desired angle (see Fig. 28).
2. Set the miter gauge (3) to the desired angle. Use only the
left side groove (2).
3. Hold the workpiece firmly against the miter gauge.
4. Feed the workpiece slowly into the blade (1) to prevent the
workpiece from shifting.
DADO CUTS
1. Unplug the power cord before removing and/or installing
dado blades.
2. When making dado cuts, a dado insert plate must be
installed in place of the regular table insert. Be sure the
rear end of dado insert plate is level with the table.
3. Instructions for operating the dado are packed with the
separately purchased dado.
4. The arbor (1) of this saw restricts the maximum width of
dado cut to ½” (see Fig.29).
5. NOTE: Make sure the arbor nut is tight and at least one
thread of the arbor sticks out past the nut.
6. Use only a 6” stackable dado set and keep the width to ½”
or less. It will be necessary to remove the blade guard and
splitter when using the dado.
Use caution when the dado is running. You have no guard
to protect you. Also, adjustable or wobble dado’s can NOT
be used on this machine.
7. Use the correct number of round outside blades and
chippers as shown in the dado’s instruction manual. Blade
and chipper total width must not exceed ½”.
8. Before starting the saw, check to make sure the installed
dado assembly will not strike the motor, table or saw base
when in operation.
To avoid injury, always replace the blade, blade guard
assembly and table insert when you are finished with the
dado operation.
CAUTION
!
Fig. 27
Fig. 28
CAUTION
!
Fig. 29
22
OPERATION