Tradesman 53433, Руководство пользователя

Страница: 18 / 30

0
o
BEVEL STOP (VERTICAL)
1. Raise the blade fully by rotating the handwheel counter
clockwise until it stops.
2. Loosen bevel angle locking knob.
3. Place a square (1) flat against the table top and against the
blade between the teeth (see Fig. 19).
4. Push the handwheel IN and turn it until the blade is against
the square. If it will not move far enough toward 0
o
to
become flat against the square, loosen adjusting screw (2)
several turns.
5. Once blade is at 90
o
to the table top, lock bevel angle
locking knob.
6.
Carefully tighten adjusting screw (2) until it touches the
bevel stop. DO NOT OVER TIGHTEN.
7. Recheck to ensure blade is still aligned at 90
o
.
BEVEL POINTER
1. Set bevel angle in vertical position (see Fig. 20).
2. If the pointer (1) does not read 0
o
, loosen pointer screw (2)
and move the pointer so it reads correctly.
3. Retighten the pointer screw.
45
o
BEVEL STOP
1. Raise the blade fully by rotating the handwheel counter
clockwise until it stops.
2. Loosen bevel angle locking knob.
3. Place the 45
o
angle of a combination square (1) flat against
the table top and against the blade between the teeth (see
Fig. 21).
4. Push the handwheel IN and turn it until the blade tilt
pointer is against the square. If it will not move far enough
toward 45
o
to become flat against the square, loosen
adjusting screw (3) several turns.
5. Once blade is at 45
o
to the table top, lock bevel angle
locking knob.
6.
Carefully tighten adjusting screw (3) until it touches the
bevel stop. DO NOT OVER TIGHTEN.
7. Recheck to ensure blade is still aligned at 45
o
.
Fig. 20
ADJUSTMENTS
Fig. 19
Fig. 21
1
3
18