Tradesman 53433, Руководство пользователя

Страница: 17 / 30

ADJUST BLADE PARALLEL TO
MITER GAUGE GROOVE
TOOLS REQUIRED
•
10mm open end or 10mm combination wrench
•
4mm hex key
•
Framing square
•
Medium size flat blade screw driver
ADJUSTMENT PROCEDURE
1. Turn saw switch OFF and remove plug from the power
source.
2.
Remove blade guard and splitter assembly, miter gauge
and rip fence.
3. Remove table insert, place blade angle at 0
o
and raise
blade to maximum height.
4. Remove blade and lower blade height adjustment to its
lowest point.
5.
Remove bolts or screws holding saw base to workbench
or stand.
6. Carefully turn saw up side down on top of the workbench
or stand.
NOTE: Be careful not to scratch the working surface of
the saw table.
7. Using the 10mm hex wrench, slightly loosen the two
middle blade alignment rod strap nuts (1) and two-rear
blade alignment rod strap nuts (2) (see Fig. 18). Note:
Leave nuts slightly snug as it makes adjustment easier.
8.
Re-mount saw blade on the table saw and tighten arbor
Nut.
9. While standing at the rear of the saw, use a medium size
flat blade screwdriver and gently pry the rear of the blade
alignment rod to the LEFT or RIGHT. Using the framing
square, simultaneously measure the distance at the front
and rear of the blade to an edge of a miter slot. When the
distances are within 1/64
”
or closer, tighten both rear
blade alignment rod strap bolts (2) while holding the rod
firmly in place.
NOTE: The blade alignment rod will only move slightly.
10. If alignment is not achieved by rear adjustment, loosen
the two front blade alignment rod strap bolts (3).
Otherwise skip to step 12.
11. While standing at the front of the saw, use a medium size
flat blade screw driver and gently pry the front of the
blade alignment rod to the RIGHT or LEFT.
Simultaneously measure the distance at the front and rear
of the blade to an edge of a miter slot. When the
distances are with in 1/64
”
or closer, tighten both front
blade alignment rod strap bolts (3) while holding the rod
firmly in place.
NOTE: The blade alignment rod will only move slightly
to the right.
12. Tighten both middle blade alignment rod strap bolts (1).
NOTE: Re-check to make sure all six bolts are properly
tightened and that the distance from the front and rear of
the blade are within 1/100
th
of an inch.
13. Install blade guard and splitter assembly.
14. Re-mount Saw to stand as outlined on Pages 10 & 11 of
this Owner’s Manual.
If blade alignment is still incorrect after
performing this procedure, please call toll free
1 (800) 243-5114, extension 221.
ADJUSTMENTS
FRONT
Fig. 18
17