TRADEair MCFRC241, Инструкция по безопасности и эксплуатации

Страница: 8 / 13

--------------------------------------------------------------------------------------------------------------
turned off. The pressure will then decrease as the air is used until the set minimum is
reached after which the pressure switch turns the motor on again.
The operator of the compressor should be well aware that during use of the compressor the
motor will cycle (start and stop) under the influence of the rising or falling pressure in the tank
and the motor will start without any warning.
The maximum and minimum pressures are factory set and should not be altered.
You can utilize either the direct outlet and/or the regulated outlet.
The pressure of the regulated outlet can be changed by turning the control knob. Rotate
the knob clockwise to increase pressure and anti-clockwise to decrease
Note: Output fittings may differ from those shown
Turn on
Turn off
Tank gauge
Regulator gauge
Pressure regulator
Air outlet
Safety valve