TracVision Mobile Receiver, Руководство пользователя

Страница: 19 / 76

MultiSat Control Panel Owner’s Manual
13
Chapter 2 - Installation
Wiring the MCP to the Antenna - R4/R5 Switchplate
If you are connecting the MCP to a TracVision R4 or R5, follow the
steps in this section to wire the MCP to the switchplate.
Modifying the Switchplate (Optional)
To configure the switchplate for an MCP installation, follow these
steps to replace the maintenance port assembly in the switchplate with
the MCP-ready maintenance port assembly supplied in the kitpack.
NOTE: The MCP-ready maintenance port assembly moves the DB9
maintenance port to the back of the switchplate. This allows you to later
connect the main control cable to the back of the switchplate, hidden from
view. However, if you wish, you may skip this step and simply connect the
main control cable to the DB9 maintenance port on the front of the
unmodified switchplate.
1. Remove and discard the two jack screws securing the
standard maintenance port assembly to the switchplate
(see Figure 2-5).
Figure 2-5 Detaching the Standard Maintenance Port Assembly
2. Disconnect the antenna’s data/power cable from the
maintenance port assembly. You will reconnect it later.
CAUTION
For your own safety, disconnect vehicle power and make sure the
circuit is dead before you begin wiring.
Remove
Jack Screws