TracVision HD7, Руководство по установке

Страница: 9 / 35

9
Connect the Power and Data Cables
Connect and hand-tighten the data and power
cables to the antenna (see Figure 11 ). Then route
the cables belowdecks through the cable access
hole. Be sure to leave an adequate service loop,
approximately 8" (20 cm) of slack, in the cables
for easy serviceability.
Connect an RF Cable to SWM (RF1)
a. Connect an RF cable to the antenna’s SWM
(RF1) connector. Then, using a 7/16" open-
end wrench, tighten the RF cable for 1/4 turn.
b. Seal the RF cable connection with silicone
sealant, self-vulcanizing tape, or equivalent.
Wire the Antenna
Figure 11 Connectors on Bottom of Antenna Assembly
RF4 RF2
DATA
TO SWM
Power
Inserter
SWM
(RF1) RF3
POWER
Non-SWM
Receivers
(DIRECTV Latin
America, DISH
Network, Bell TV,
and Legacy
DIRECTV
Receivers)
7