BCS 100cm Rotary Mower Attachment
Page 6
TWT/100RM/0617
Operation
Always disengage the power take-off (PTO) when changing direction or location of operation.
Do not replace the blades or attempt to undertake any maintenance of the mower while the
machine is running.
Only qualified persons should operate the machine.
If any abnormal vibrations occur STOP the engine immediately and visually inspect the machine
and implement for any signs of damage.
IMPORTANT: Read all machine and implement manuals thoroughly before using the rotary
mower.
Commencing work
Use the handlebar height adjuster to set handlebar height before
commencing work.
NOTE: Disengage the drive to the mower before selecting reverse
gear.
Raise the throttle to speed, release the clutch lever gently and fully,
keeping the red machine stop lever (OPC) depressed as engine will
stop if released.
Increase throttle speed.
The mower deck should be level for an even mowing height.
If adjustment is required, remove the wheel and remount it into a
higher or lower position as required (fig.4/4).
The cutting height ranges from 2” to 5”. It is
recommended that a maximum of 2” be removed at
each mowing, then reduce it to a desired height with a
second mowing.
To adjust the cutting height unhook the split pin [D] and
use the adjustment lever [E] as shown on the sticker
[F] (fig.4/5).
Fig 4/4
C
A
B
F
D
Fig 4/5
E
