TU600A
Trackunit TU600A, Technical Manual v1.1, June 2021
Page 27
This equipment should be installed and operated with minimum distance of 20 cm
between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Déclarations selon le CFR 47 Sections 2.1091 et RSS-102:
Respectant les informations relatives à l’exposition aux radiations de fréquences radio, on déclare
que cet équipement respecte les limites d’exposition aux radiations de la FCC aux conditions
prévues pour un environnement non contrôlé.
Cet équipement doit être installé et fonctionner à une distance minimale de 20 cm entre
l’appareil irradiant et votre corps.
Cet émetteur ne doit pas être installé ou utilisé en conjonction avec d’autres antennes
ou d’autres émetteurs.
Statements according to CFR 47 Part 15.105 and ICES-003:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules and ICES-003 of the Canadian rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Automotive, off-road vehicles, machinery etc.
UN regulative ECE R10 EMC rev. 05/01 in accordance with EU regulation 661/2009.
o
Tested by ECE R10 rev05/01.
The TU600A product complies with the essential requirements of the Directive 2006/42/EC
and EU regulation 167/2013 construction machinery:
o
Tested in compliance to EN ISO 14982, ISO 13766-1, -2, EN 13309, DIN EN 12895,
see below.
Statement for ISO 13849-1 safety
1. The TU600A products are when installed not a vital part in the machine safety system, but
it can be used as access control/immobilizer if paired with a keypad (i.e. DualID II), ibutton
or wireless (Bluetooth LE enabling). This function depends on correct installation (see
install guide) and requires that the output wire is connected to a relay to control the starter
motor.
2. When the emergency stop on the machine is activated, the unit and keypad functions will
be disabled. The internal battery ensures that a GPS position still can be acquired on an
hourly basis.