Page 12 of 26
Afterwards you can not switch the equipment on because of the empty Accu.
Now charge the Powdersave II with the charger. After termination of the
loading procedure on the Accu meter (right above on the display) can be
read how much energy could to be invited. The Accu meter should
announcement fully, if this is not the case, then the Accu is defective, aged or
"sluggardly".
Important:
After choosing the menu “Discharge Batt” leave the instrument till
itself switches off (do not press any button like HOME etc. !) !
6.
Charger
6.1.
Description of the charger
This charger is microprocessor-controlled and automatically recognises the type
of battery to be charged. The input voltage is either 230 Volts or 115 Volts +/-
10 % AC, 50 or 60 Hz (see label on the bottom of the charger). It has approval
for usage in a dry environment by relevant authorities.
6.2.
Charging the battery
1.
Make sure that your local mains voltage conforms with the details on the
label on the bottom of the charger before the first usage.
2.
Connect the charger to the wall socket with the power cable included.
3.
Now the red LED will be on permanently until the charging process is
completed. When the red LED is flashing the battery is full loaded.
4.
Charge end: With reaching the full charge, the red LED is blinking. The
Battery has now its full capacity. If the equipment remains attached, tis
constantly supervises the charge of the Battery and undertakes
independently reloading for the compensation of the self discharge.
The load time of a completely empty Battery (capacity 2100 mAh) amounts
to approx. 1 hour, for a part discharge Battery accordingly less.
6.3.
Safety precautions
•
Do not open the charger (electrical hazard, loss of warranty)
•
Keep the unit dry. Allow for warm-up before usage after storage in cold
environment (condensed humidity).
Illustration:
Battery-charger