TQC CureView AB8000, Руководство по эксплуатации

Страница: 11 / 32

11 |
7.1 Start-up sequence
• Start the control computer or laptop.
• Once windows is launched start the TQC CureView.
• After 3 beeps the initiation of the TQC CureView in completed.
• Start the GOC software.
7.2 Test Panels
Prepare the panel as required by the test to performed. Make sure that no
wet/uncured paint or any other chemicals are applied at the area’s used by
the probes or pins. Only below depicted area can be used.
7.3 Calibration interval
The TQC CureView is supplied with 4 controllers each measuring and
controlling 8 channels. TQC advises to have an annual calibration interval.
Contact TQC or a local representative for information on how to calibrate the
TQC CureView.
7.4 Lamp maintenance
The carefully selected TQC Infra red heaters have a life expectancy of at least
5000 burn hours. In end this depends on the use of the lamps.
The replacement of the lamps should be performed as mentioned in the
chapter: “Replacing the Heater lamps” and should only be done by
authorized personnel.
7.5 Software
The TQC CureView operates in conjuction with Gradient Oven Control and
Ideal Finish software.
7 INSTRUMENT PREPARATIONS
x 35 mm x 35 mm
98 mm
x 12 mm
x 12 mm
74 mm
570 mm
500 mm