ECO 1-7639 060220 REV.- FORM: 8224
4 of 4
THERMOSTAT INSTALLATION INSTRUCTIONS
Determine the location where the thermostat is to be mounted. It should be installed about 54” above floor level where there
is good air circulation. Avoid heat sources such as lamps,direct sunlight, fireplaces or walls containing air conditioning and
heating ducts. Do not install where anything can obstruct free air flow such as drapes or doors.
1. Disconnect the power supply to the HotPod.
2. Follow instructions included with the thermostat for installation procedures.
3.
Choose a proper location for the thermostat following instructions outlined above. Insure proper fit. for dimensions see
below (FIG 4).
4.
For the thermostat connection remove approximately 2 1/2” of the outer jacket and strip the individual conductors
approximately 1/4”
. Use electrical materials approved by applicable codes.
5. Feed electrical wires from the system through the opening in wall plate. Wiring must not interfere with the operation of
the thermostat.
6. Connect the wires to the proper terminals. (See Fig.3)
7.
Once you have finished installing the thermostat in the desired location, restore power to the Hotpod.
8. Refer to instructions included with the thermostat for setup and operating details.
THERMOSTAT SETUP INSTRUCTIONS
Once you have restored power to the Hotpod the thermostat will begin to operate.
1. Press and Hold the
+
and
-
buttons for 3 seconds
2. Select TECH button at lower left
3.
Configure the installer options as you desire by changing the settings using the
+
or
-
buttons. Press PREV or
NEXT buttons to move from one step to another.
4. THE FOLLOWING STEPS MUST BE CHOSEN FOR THE HOTPOD SYSTEM TO WORK CORRECTLY.
5. Step 1: Your preference
6. Step 2:
COMP DELAY
set to
OF
7. Step 3 through 8: Your preference
8. Step 9:
SYS MODE
set to
HC
9. Step 10:
FAN OPER
set to
EL
10.
To exit TECH setup: press and hold the
+
and
-
buttons for 3 seconds, or wait 20 seconds.
11.
For Wifi setup: follow instructions included with the thermostat.
Fig. 4
