TP TP 235 MOBILE, Руководство пользователя

Страница: 30 / 80

Ó
Copyright 2015
30
User Manual: TP 235 MOBILE / TP 275 MOBILE from date 01.12.2016
Note the machine may only be operated when the indicator (5) is in the green area.
Once the wood chipper shall be parked or transported, lower the ejector spout all the way down
so that the indicator (5) is at the rear in the blue P area. The transport lock on TP VARIO SPOUT is
activated automatically when the ejector spout is lowered completely. Check before transport on
public roads that the transport lock (6) is engaged. During transport, the TP VARIO SPOUT must
always be within the machine's width and the sliding bolt (2) shall be locked.
8.3 In-feed speed
The wood chipper's in-feed speed is controlled by the TP CSC, which automatically regulates the
amount of oil to the feed rollers’ oil motors. TP CSC is programmed in TP NAVIGATOR, where the
desired chip length is entered (see instructions for TP NAVIGATOR in chapter 9). This ensures that
there is always the correct in-feed speed, independent of the disc's rpm.
The table shown below provides the actual rpm of the feed rollers with the entered woodchip
length.
Woodchip length
Model Disc
rpm 6 mm
rpm
8 mm
rpm
10 mm
rpm
12 mm
rpm
14 mm
rpm
16
rpm
TP 235 MOBILE 1160 17 22 28 33 39 44
TP 275 MOBILE 1372 20 26 33 40 46 52
8.4 Start-up and commissioning the wood chipper
Start the engine with the ignition key and let it run idle for a few minutes. Coupling of the wood
chipper's disc can be subsequently activated in TP NAVIGATOR (see instructions for TP NAVIGATOR
in chapter 9).
In TP NAVIGATOR, the start-up process is activated automatically, where the belts between the
wood chipper and the engine are automatically coupled at the same time as the engine's rpm is
increased from idle to nominal rpm. TP NAVIGATOR ensures that the belts have the correct
pre-tension.
Prior to the wood chipper starting, it must be ensured that the TP VARIO SPOUT is at the operating
height (see TP VARIO SPOUT in chapter 8).