TL-WA830RE
300Mbps Wireless N Range Extender User Guide
41
Figure 4-28 SNMP Settings
SNMP Agent
-
Select the radio button before
Enable
will enable this function if you want to
have remote control through SNMPv1/v2 agent with MIB-II. Select the radio button before
Disable
will disable this function. The default setting is
Disable
.
SysContact -
The textual identification of the contact person for this managed node.
SysName -
An administratively-assigned name for this managed node.
SysLocation -
The physical location of this node.
Note:
Specifying one of these values via the Device's Web-Based Utility makes the corresponding object
read-only. If there isn't such a config setting, then the write request will succeed (assuming
suitable access control settings), but the new value would be forgotten the next time the agent was
restarted.
Get Community -
Enter the community name that allows Read-Only access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is “
public
”.
Get Source -
Get source defines the IP address or subnet for management systems that can
read information from this 'get' community device.
Set Community -
Enter the community name that allows Read/Write access to the Device's
SNMP information. The community name can be considered a group password. The default
setting is “
private
”.
Set Source -
Set source defines the IP address or subnet for management systems that can
control this 'set' community device.
Note:
A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as
IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all
requests under the corresponding community name.
Click the
Save
button to save your settings.
