TD-W8910GB
54M Wireless ADSL2+ Router User Guide
45
2. Enter the following data:
¾
Destination Network Address:
The
Destination Network Address
is the address of the
network or host that you want to assign to a static route.
¾
Subnet Mask:
The
Subnet Mask
determines which portion of an IP Address is the network
portion, and which portion is the host portion.
¾
Gateway IP Address:
If the
Use Gateway IP Address
checkbox is selected, you should
type the Gateway address exactly in the text box, or else, the default Gateway address will be
adopted for the Static Route.
¾
Use Interface:
If the
Use Interface
checkbox is selected, you should select the Interface
name in the text box, or else, the default Use Interface will be adopted for the Static Route.
3. Click
the
Save/Apply
button to save it.
To remove a static routing entry:
1. Select
the
Remove
check box according to the entry in the Figure 4-36.
2. Click
the
Remove
button, and the entry will be deleted.
)
Note:
Default Gateway IP address should be specified since MER Interface is selected.
4.4.7.3. RIP
Choose “
Advanced Setup
”
Æ
“
Routing
”
Æ
“
RIP
”, you can see the RIP (Routing Information
Protocol) screen, this screen allows you to configure the RIP (shown in Figure 4-38).
Figure 4-38
To activate RIP for the device, select the
Enabled
radio-button for
Global RIP Mode
. To
configure an individual interface, select the desired RIP version and operation, followed by placing
a check in the
Enabled
checkbox for the interface.
If you are sure about the settings, click the
Save/Apply
button to save the configuration.
