SafeStream Multi-WAN Router
03
Introduction
Reset
Use the button to restore the router to the factory defaults. With the router powered on, use a pin to
press and hold the Reset button (about 5 seconds) until the SYS LED flashes quickly. Then release the
button and wait for the router rebooting to its factory default settings.
■
Rear Panel
The rear panel is shown as the following figure. Here we take TL-ER6020 as an example.
Figure 1-5
Rear Panel
100-240V~ 50/60Hz 0.3A
Power Socket
Connect the female connector of the power cord here, and the male connector to the AC power outlet.
Please make sure the voltage of the power supply meets the requirement of the input voltage (100-240V~
50/60Hz).
Grounding Terminal
The router already comes with lightning protection mechanism. You can also ground the
router through the PE (Protecting Earth) cable of AC cord or with Ground Cable. For detailed
information, please refer to the
Lightning Protection Guide
from the training center of our website
http://www.tp-link.com/en/configuration-guides.html.
Kensington
The kensington lock port is used to connect to a kensington lock to secure your router.
Caution:
Please use the provided power cord.
