2.3 Appearance Description
2.3.1 Front Panel
Figure 2-1 Front Panel
The following parts are located on the front panel of the Switch:
¾
10/100/1000Mbps Ports:
Designed to connect to the device with a bandwidth of 10Mbps,
100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED.
¾
SFP Ports:
Designed to install the SFP module. Port 15F shares the same LED with Port 15T
and Port 16F shares the same LED with Port 16T. The Port 15F (16F) and Port 15T (16T) are
referred to as “combo” ports, which means they cannot be used simultaneously, otherwise only
SFP ports work.
Note:
When using the SFP port with a 100M module or a gigabit module, you need to configure its
corresponding
Speed and Duplex
mode on
Switching
→
Port
→
Port Config
page. For 100M
module, please select
100MFD
while select
1000MFD
for gigabit module. By default, the
Speed
and Duplex
mode of SFP port is 1000MFD.
¾
Console Port:
Designed to connect with the serial port of a computer or terminal for monitoring
and configuring the Switch.
¾
LEDs
Name
Status
Indication
On
Power is on.
Flashing
Power supply is abnormal.
Power
Off
Power is off or power supply is abnormal.
On
The Switch is working abnormally.
Flashing
The Switch is working normally.
System
Off
The Switch is working abnormally.
On
A 1000Mbps device is connected to the corresponding
port.
1000Mbps
Off
A 10/100Mbps device or no device is connected to the
corresponding port.
On
A device is connected to the corresponding port, but not
activity.
Flashing
Data is being transmitted or received.
Link/Act
Off
No device is connected to the corresponding port.
7
