TP-Link Jetstream L2 T2500-28TC, Руководство по установке

Страница: 9 / 24

JetStream L2 Managed Switch
05 Introduction
is on. Pressing the mode switch button, the Speed LED will turn off and the PoE LED will light up. Then
the PoE LED will turn off after being on for 60 seconds and the Speed LED will light up again.
LED Indication
PWR
On : The switch is powered on.
Off : The switch is powered off or power supply is abnormal.
Flashing : Power supply is abnormal.
SYS
Flashing : The switch works properly.
On or Off : The switch works improperly.
FAN
Green : All the fans work properly.
Yellow : Not all the fans work properly.
Off : The switch works improperly.
PoE Max
(When the PoE LED
is on)
On : The remaining PoE power is equal to or less than 7W.
Flashing : The remaining PoE power is equal to or less than 7W and lasts for more than
2 minutes.
Off : The remaining PoE power is larger than 7W.
Speed or PoE
(When the Speed
LED is on)
Green On : Running at 1000Mbps, but no activity.
Green Flashing : Running at 1000Mbps and is transmitting or receiving data.
Yellow On : Running at 10/100Mbps, but no activity.
Yellow Flashing : Running at 10/100Mbps and is transmitting or receiving data.
Off : No device is linked to the corresponding port.
Speed or PoE
(When the PoE LED
is on)
Green On : The port is supplying power normally.
Green Flashing : The supply power exceeds the correponding port's maximum power.
Yellow On : Overload or short circuit is detected.
Yellow Flashing : Power-on self-test failed.
Off : Not providing PoE power on the port.
SFP
SFP1, SFP2
Note: SFP1 and SFP2 for T2500G-10MPS, SFP for T2600G-28MPS
Green On : A 1000Mbps device is linked to the corresponding port, but no activity.
Green Flashing : A 1000Mbps device is linked to the corresponding port and data is
being transmitted or received.
Yellow On : A 100Mbps device is linked to the corresponding port, but no activity.
Yellow Flashing : A 100Mbps device is linked to the corresponding port and is
transmitting or receiving data.
Off : No device is linked to the corresponding port.
Console Port (RJ-45/USB)
Designed to connect with a computer for monitoring and configuring the switch. For T2500G-10TS/
T250 0 G -10 M P S / T26 0 0 G -18 T S / T26 0 0 G -28 T S / T26 0 0 G -28 T S - D C/ T26 0 0 G -28 M P S /
T2600G-28SQ/T2600G-52TS, the switch has an RJ-45 console port and a micro-USB console port.
Console input is active on only one console port at a time. By default, the micro-USB connector takes
precedence over the RJ-45 connector.
10/100Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps.