Toyotomi zibro RS - 24, Руководство по эксплуатации

Страница: 7 / 16

!
!
!
4
7
Before igniting the heater, always check the fuel indicator

to see whether the
removable tank needs filling up (Green=full, Red=empty).
Always ignite the heater with the knurled wick adjustment knob

. Never use
matches or a cigarette lighter.
Follow the procedure below:
1 Turn the knurled wick adjustment knob

clockwise to its stop (Fig. K). If you
apply more pressure you may turn it slightly further; however, it will
automatically return to the start position. When you have set the wick to its
highest position, this action will automatically activate the safety device.
When you have ignited the heater and it shuts off again shortly after, the batteries
need to be replaced. It is best to use new alkaline batteries (4x C-size).
If the heater has been used only a few times and the wick adjustment knob is not
locked, first turn the wick adjustment knob (Fig. L) completely left, before putting
the wick in the highest position for ignition
(Section C) .
After having ignited the heater, always check whether the combustion
chamber

is level, by sliding it slightly to the left and the right by combustion
chamber handle

(Fig. E). This should be a smooth movement. If the combustion
chamber is not level, this will cause smoke and soot to develop.
d
BURNINg OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can check
whether the heater is burning well. Too high a flame may cause smoke and soot,
whereas too low a flame causes smells. The page opposite the folding page shows
the minimum and maximum permissible burning heights of the flame (Fig. R).
If the flame remains low after the adjustment, the wick height must be
adjusted
(refer to Section G) .
Burning that is too low may be caused by:

insufficient fuel (fill the tank)

poor fuel quality (contact your dealer)

insufficient ventilation (put window or door ajar)

wastage of the wick (contact your dealer or replace the wick, refer to section M )
E
SWITCHINg OFF THE HEATER
Push the OFF-button

. The flame will extinguish after a little while (Fig. M).
K
M
L
E