Toyota 62-8FDU15, Руководство по ремонту

Страница: 135 / 222

7-133 7 DISPLAY
500 mm
(19.7 in)
V mast FV·FSV mast
a
3. No-load vertical condition check
Store the output voltage of the load sensor in no-load
state in the controller. At this time, the following con-
ditions must be satisfied:
▪ For the V mast, set the lifting height to about 500
mm (19.7 in) and use a goniometer to check that
the mast is vertical.
▪ For the FV/FSV mast, set the rear cylinder rod
projection to about 100 mm (3.93 in) and use a
goniometer to check that the mast is vertical.
▪ On a vehicle with attachment , set the mast ver-
tical with the attachment at a height of 500 mm
(19.7 in) and perform relief at the topmost posi-
tion.
▪ Set the mast in the vertical position from the
backward tilted position by operating the tilt lever
in the forward tilting direction.
50 mm
(2.0 in)
50 mm
(2.0 in)
5 m (16 ft)
4. Tire straight traveling position check
Store the tire angle sensor output voltage in the con-
troller in the condition of the vehicle traveling straight
ahead.
Condition of the vehicle traveling straight ahead
means that the deviance to left or right is within 50
mm (2.0 in) when the vehicle travels for 5 meters (16
ft) with the steering being fixed.
5. Loadmeter 0 set (0 set of the load gauge) check
For all the V/FV/FSV mast, the mast is to be vertical
and the fork height is to be 500 mm (19.7 in).
7