Toyostove Laser 30, Инструкция по установке и эксплуатации, Страница: 25 / 31

6. Insert the bent joint to the exhaust mouth of the standard flue pipe. Cut the inlet hose for desired length
if necessary. Attach the L-shaped hose to each end of the inlet hose and attach the L-shaped hose to the
intake mouth of the standard flue pipe. Secure the L-shaped hose to the intake mouth with the hose
band. Plug the unused exhaust and intake mouth with the caps provided with the heater. Make sure the
caps fit tightly onto the mouth (See Fig. 10).
NOTE: If the inlet hose is not smoothly inserted into the L-shaped hose, apply water or soap suds to
the inlet hose.
7. Move the heater into position. Remove the filter and the two (2) screws holding the upper rear cover.
Connect the bent joint to the exhaust outlet mouth and attach the L-shaped hose to the intake inlet
mouth. Make sure all connections are tight (See Fig. 11).
25
Hose Band
Intake Air Cap
Exhaust Air Cap
L-Shaped Hose
Fig. 10
Fig. 11
Bent Joint
;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;
;;;;;;;;;;;;;;;;