Setting 1st Timer/2nd Timer:
1. Make sure the clock is set. If not, press the hour and minute button until the correct time is indicated.
2. Press 1st Timer button. Use the up and down arrows to set the time at which you want the room to return
to normal temperature. This would be 4:00PM to have the room start heating up at 4 pm. You have ten
seconds from the time you push the button to enter this setting.
3. After ten seconds the display will change to Temp. The Temp side of the display will show the default 56
degrees. Use the up arrow to adjust this temperature setting to the desired 65 degrees. The 1st Timer is
now set and you are in the 1st timer mode. To return to the normal operation mode, press the 1st timer
button. If you want to set the 2nd Timer, press 2nd Timer button and repeat the process with the desired
settings.
To return to normal setting once a timer has been pushed (example a child press 1st timer button and you
don’t want the temperature lowered) just press the button again.
Note:
The heater operates at the same hour and at the same temperature, if it has once been set for
such hour and temperature, unless their settings are changed.
Note:
If a power failure occurs (for longer than 20 minutes) while in operation, time and temperature
settings are cancelled. When this happens, “AM”, and “PM” lamps start flashing. Reset desired
times and temperatures.
Note:
To cancel the timer operation, press the “1st” Timer button or the “2nd” Timer button again.
Ordinary operation will then be restored.
Note:
After the heater has been set for a particuler hour and temperature it will operate at that setting
each time the timer button is turned on unless the settings are changed.
MANUAL COMBUSTION
Important:
This feature is for testing purpose only!
This heater also can be kept burning at desired combustion mode (High, Medium or low) manually, regardless of room
temperature.
1.
Press the “UP-HOUR“ button and “DOWN-MIN“button at the same time for more than three (3) seconds when
ON / OFF switch is “ON“.
2.
P1, P2 or P3 will be displayed on the Digital Indicator;
P1 = Low mode
P2 = Medium mode
P3 = High mode
Then select desired combustion mode by pressing “UP-HOUR“ or “DOWN-MIN“ button. “UP-HOUR“ buttonchanges
combustion mode to higher, “DOWN-MIN“ button changes combustion mode to lower.
3.
To clear, press the “UP-HOUR“ button and “DOWN-MIN“ button at the same time for more than (3) seconds until
normal temperature display returns.
TURNING HEATER OFF
Press ON/OFF switch to “OFF” position. POWER lamp will flash and will go out. Circulation fan and blower
motor continue to run for approx. three (3) minutes to cool down the heater. Make sure POWER lamp goes
out when the fan stops.
11
Содержание Laser 30
Страница 30: ...30 ...
