Townsend Labs Sphere L22 Precision Microphone System Guide
Installation and Configuration
10
Preamp Connection
To connect the Sphere to your preamp:
1.
Connect the 5-pin side of the included breakout connector to your Sphere mic.
This cable breaks out into two conventional 3-pin XLR cables that you will connect to the preamp.
2.
Route the Sphere’s white XLR output (labeled
1-Front
) to the
MIC 1
connector on the preamp.
3.
Route the Sphere’s red XLR output (labeled
2-Rear
) to the
MIC 2
connector on the preamp.
4.
Enable Channel Linking for the pair of channels on your preamp (if applicable).
This automatically keeps both preamp channels set to the same level when either is adjusted.
5.
Disable any filters, pads, EQ, or other processing on your preamp.
6.
Enable 48 V phantom power (P48) on both channels of the preamp.
Two LEDs light inside the headbasket to indicate that phantom power is applied to both mic channels.
Figure 2-1
Connecting Sphere mic to the preamp
If your mic preamp has digital gain control (e.g., Avid Omni or Universal Audio Apollo), you can easily
calibrate each channel to the same precise level. We recommend enabling stereo linking for the preamp
channels so the gain for both channels can be adjusted simultaneously.
If your preamp does
not
have digital gain control or precision analog stepped gain adjustment, proceed
to
Preamp Calibration
on page 13.
Содержание Sphere L22
Страница 1: ...Precision Microphone System Hardware and Software Guide Version 161003 ...
Страница 2: ......