100001021-50
Figure 54: Front panel base.
Figure 55: Securing tab.
Figure 56: Removing the side panel.
Figure 57: Access panel.
1. Remove front panel base (Figure 54). Also remove rear panel base if Black Diamond Burner is fitted.
2. Push up on the heat shield, at the right end of the unit near the middle, enough to clear the securing tab (Figure 55).
FRONT PANEL BASE
3. Pull the top of the right panel toward the center of the unit using caution not to scratch the back panel (Figure 56).
4. Once the right panel is tilted inwards it can be lifted clear of the burner tray and removed.
NOTE: The right hand side rock cluster may need to be removed to prevent damage while working through the
access hole. Covering the sand with paper or cardboard will also minimize disturbance during the servicing process.
5. The access panel is now visible (Figure 57).
6. Reassemble in reverse order.
WARNING: The control box shield, access panel and
gasket must be replaced. Failure to do so will overheat
and cause premature failure of the control.
38
TCWS54D2 091418-40
Quick Panel Removal for Valve Service
