Town & Country Fireplaces TC54.NG03C2, Инструкция по эксплуатации

Страница: 4 / 16

5. Remove access cover from side of fi rebox.
6. Remove access cover from side of fi rebox. Secure
the bulkhead plate and gasket to the fi rebox. (2
screws) Attach the ignition and sensor wires to
the module on the front valve. Red end to the
connector marked by the red dot, white end to
the connector marked by the white dot. Repeat
for the rear valve.(Fig. #4 & 4b)
7. Place burner shield into unit, fl exing right shield
leg slightly to clear manifold. Make sure both
pilots protrude through center hole. (Fig. #5)
NOTE: The shield sits at an approximately 15
degree angle to the base of the fi rebox.
8. Cover the glossy surface of the burner shield to
prevent surface damage while connecting pilots
to the underside of the burner tray.
Attach the front pilot to the front of the burner
tray fi rst
then the rear pilot to the rear of the tray.
(Fig. #6)
NOTE: Start screws with fi ngers fi rst to prevent
cross-threading.
9. Place front media spacer to the front of the tray.
(Fig. #7)
RED END
Fig. #4
Fig #4b
RED END TO
RED DOT
WHITE END TO
WHITE DOT
TC54.NGO3C2 070211-16
Fig #5
Fig #6
Fig #7
INSTALL SHIELD
ATTACH PILOTS
INSTALL FRONT MEDIA
SPACER
4