Town & Country Fireplaces TC42.NG06D2, Руководство по установке

Страница: 5 / 16

5
TC42_NG06D_060117-16
5056.426D2-A
Ember Material
A large bag of glowing ember
material is supplied with the burner
kit and needs to be installed on the
burner to ensure optimum perfor-
mance and flame appearance.
1. Pull apart the material into
ember size pieces (approxi-
mately 1” squares) and gently
place them into the burner pan.
Do not compress, leave them
loose for best performance.
2. Fill the burner pan level with
the top of the pan at rear, and
gradually sloping forward down
to the firebox floor at the front,
covering both burner tubes.
3. Place remaining ember mate-
rial outside of the burner pan
as desired to cover-up gas
lines and brackets.
Gas plumbing and vent connec-
tions should be completed before
proceeding.
The logs are are fragile and
should be handled with care.
Unpack and inspect log set.
There should be a total of 7 logs.
Position the logs as indicated by
the following pictures. Place the
rear log back against the tabs
located at the back of the grate.
(Figure 10).
Log Set Assembly
Note: Ember material placement and amount will affect flame
appearance. More ember material results in lower flame height.
Add or remove as needed until desired flame affect.
Log grate
Glowing embers
Figure 9: Ember material placement.
Log 1
Figure 10: Log 1 placement.