TC30_NGO3D_270315-16
10
5056.42903D
WARNING
This conversion kit
shall be installed by a
qualified service agency
in accordance with the
manufacturer's instructions
and all applicable codes and
requirements of the authority
having jurisdiction.
If the information in these
instructions is not followed
exactly, a fire, explosion
or production of carbon
monoxide may result
causing property damage,
personal injury or loss of
life.
The qualified service agency
is responsible for the proper
installation of this kit. The
installation is not proper and
complete until the operation
of the converted appliance is
checked as specified in the
manufacturer's instructions
supplied with the kit
.
If the unit is to be used on propane
convert as follows using the
components supplied with this
fireplace:
CAUTION
The gas supply and electrical power
shall be shut off before proceeding
with the conversion.
Note:
Factory supplied components must be used
to ensure correct input. After conversion
confirm proper manifold pressure.
1. Ensure the burner, pilot and gas
supply are turned off, and the
appliance has cooled.
2. Using a 1/2” wrench, undo the natural gas
burner orifice, (marked
#32
). (Fig. #15)
3. Apply a small amount of pipe joint
compound to the threads of the 1.9mm
replacement propane burner orifice to
ensure a good seal, before screwing it
into the fitting.
4. Open primary air shutter fully.
5. With a 7/16” wrench loosen the pilot head
on the pilot assembly (Fig. #16)
Fig #15
Fig #16
Propane Conversion
MAIN BURNER
ORIFICE (5022.76)
