MOUNT THE STABILIZER & FIN
❍
1. In order to complete this section you will need the
following items as shown in the photograph above. You will
also need the wing (not shown) for alignment purposes.
#1 Fuselage (1)
#2 Stabilizer (1)
#3 Elevator (1)
#4 Fin (1)
#5 Rudder (1)
#6 CA Hinges (7)
❍
2. Test fit the hinges into hinge slots in the stabilizer and
elevator and the fin and rudder. If necessary insert a #11
blade into the hinge slots and run it back and forth to
enlarge them slightly. Important Note: Remember to insert
the hinges with the cut running the correct direction.
❍
3. Use a hobby knife with a sharp #11 blade and cut the
covering from the openings on both sides of the fuselage for
the stab. Also cut the covering from the opening in the top of the
fuselage for the fin. Remove the elevator from the stab.
10
ASSEMBLE THE FUSELAGE
