Tower Hobbies BMT131000BLG, Инструкция по безопасности и эксплуатации

Страница: 9 / 16

9
Using the Window Vacuum:
1. Once the window vacuum has been assembled, press the On/Off button to
turn it on. The motor will start up and the LED indicator light on the lower part
of the unit will light up blue to indicate the unit has been turned on.
2. Press the On/Off button again while the unit is in operation to turn it off. The
motor will stop working and the LED indicator light on the lower part of the
unit will go out to indicate the unit has been turned off.
3. To use the vacuum cleaner, turn it on and run it over the area to be cleaned
in a straight line, from top to bottom or from side to side. The vacuum will
automatically absorb any water or moisture contained within that area and
store it in the water tank. Repeat this process as many times as necessary until
the relevant area has been fully cleaned.
Using the Spray Bottle:
1. This unit comes complete with a spray bottle, which can be filled with water or
a soft, non-abrasive detergent to clean windows or glass surfaces.
2. To fill this bottle, unscrew the spray nozzle and put it to one side. Fill the bottle
with water, replace the spray nozzle and turn it clockwise to tighten it and
secure it into place.
3. To use the spray bottle, press the trigger on the nozzle. Water will spray out
onto the surface to be cleaned.
Using the Cloth Head Attachment:
1. This unit comes complete with a cloth head attachment and microfibre cloth
attachment, for use with the included spray bottle.
2. To use the cloth head attachment, begin by attaching it to the spray bottle.
To do this, remove the spray nozzle from the bottle and thread it through the
opening at the front of the cloth head attachment until it sits flush inside it.
3. Once the nozzle is securely positioned inside the opening, gently press the
two tabs on either side inwards and fit the nozzle into the securing ring. The
securing ring is correctly installed when the protruding part is aligned with the
back part of the cloth head attachment. If the two parts are correctly aligned,
they will automatically click into place.
4. Once the cloth head attachment is correctly installed, fit the microfibre cloth
over the top of it using the included straps and Velcro pad.
5. The cloth head attachment is now ready for normal use.
Note: Ensure the spray bottle has been filled with water before attempting to use
the cloth head attachment.
6. To use the cloth head attachment, begin by spraying water onto the surface
to be cleaned, as described in the ‘Using the Spray Bottle’ section above. Once
the surface is wet, run the cloth head attachment over the areas to be cleaned,
as required. Once the surface has been cleaned, use the main unit to dry out
the affected areas if necessary.