Tower Hobbies BMT131000BLG, Инструкция по безопасности и эксплуатации

Страница: 11 / 16

11
Cleaning the Unit Body:
1. Before cleaning the unit body, ensure the unit is disconnected from the mains
supply and not in operation.
2. Use a damp cloth to clean the unit body. Never use any abrasive cleaning
materials or solvents, as these could cause damage to the surface of the unit.
WARNING! DO NOT allow any liquids into any part of the unit other than the water
tank, as this could cause damage to the electrical components and cause it to
malfunction.
Draining the Water Tank:
1. Any water or moisture picked up by the unit while in normal operation is
stored in the removable water tank. When this tank is full, it will need to be
drained.
2. To drain the water tank, open the tab at the front of it and insert a hose or tube
(not included) into the drain plug opening. Drain out the water in the tank,
then clean it, as described below.
Cleaning the Water Tank:
1. To clean the water tank, begin by removing it from the main body of the unit.
To do this, press down on the grooved tab at the top of the water tank and
pull it firmly towards you and away from the main body of the unit until it
detaches.
2. Once the water tank has been detached from the unit, separate the top half
from the bottom half to open it.
3. When the water tank is open, carefully pull the tube separator out until it
detaches from the bottom half of the tank.
4. Rinse the separator and the two halves of the water tank under running water
to clean them. Allow the parts to dry thoroughly before reassembling the water
tank.
WARNING! The water tank is NOT dishwasher safe. DO NOT attempt to clean the
water tank in the dishwasher.
5. Once the tank has been cleaned, re-assemble it by connecting the tube
separator to the bottom half of the tank, then attaching the top half of the
tube to the lower half so that the two are secured together.
6. When the water tank has been reassembled, press down on the grooved tab at
the top of the tank and align it with its corresponding notch on the main body
of the unit. Once the two parts are aligned, push the water tank back into the
appliance until it slots into place. When the water tank is in place, release the
grooved tab; it will automatically slot into place as well and secure the water
tank to the main unit.
Storing the Appliance:
1. Ensure the appliance is fully dry and the water tank has been drained before
storing.
2. Once the appliance is dry and the water tank has been drained, store it in a
cool dry place out of the reach of children, preferably in its original packaging.
8 - Cleaning & Care