TOUGHCUT Diamond 400, Инструкция по эксплуатации

Страница: 29 / 54

8. TROUBLE SHOOTING
-29-
WARNING
- For any information or problem contact your area dealer or our technical service center. The necessary interventions
must be carried out by specialised technical personel.
- Before carrying out any fault service or maintenance work, please always TRUN OFF THE SWITCH, UNPLUG
POWER CABLE, WAIT FOR SAW BLADE TO COME TO STANDSTILL.
Trouble Possible Cause Solution
Saw stops or will not start
1. Overload tripped on motor
2. Saw unplugged from wall or motor
3. Fuse blown or circuit breaker tripped
4. Cord damaged
1. Allow motor to cool and reset overload
switch on motor
2. Check all plug connections
3. Replace fuse or reset circuit breaker
4. Replace cord
Does not make accurate
45° or 90° cuts
1. Stops not adjusted correctly
2. Angle pointer not set accurately
1. Check blade with square and adjust
stops
2. Check blade with square and adjust
pointer
Material binds blade when
ripping
1. Fence not aligned with blade
2. Warped wood
3. Excessive feed rate
4. Splitter not aligned with blade
1. Check and adjust fence
2. Select another piece of wood
3. Reduce feed rate
4. Align splitter with blade
Saw makes unsatisfactory
cuts
1. Dull blade
2. Blade mounted backwards
3. Gum or pitch on blade
4. Incorrect blade for cut
5. Gum or pitch on table
1. Sharpen or replace blade
2. Turn blade around
3. Remove blade and clean
4. Change blade to correct type
5. Clean table
Blade does not come up
to speed
1. Extension cord too light or to long
2. Low shop voltage
3. Motor not wired for correct voltage
1. Replace with adequate size cord
2. Contact your local electrical company
3. Refer to motor junction box
Saw vibrates excessively
1. Stand on uneven floor
2. Damaged saw blade
3. Bad V-belts
4. Bent pulley
5. Improper motor mounting
6. Excessive play in raising mechanism
7. Loose hardware
1. Reposition on flat, level surface
2. Replace saw blade
3. Replace V-belts
4. Replace pulley
5. Check and adjust motor
6. Adjust worm and arbor bracket
7. Tighten hardware
Rip fence binds on guide
rails
1. Guide rails or extension wing not
installed correctly
2. Guide of rip fence not adjusted
properly
1. Reassemble guide rails, refer to fence
manual
2. Adjust guides, refer to fence manual
Material kicked back from
blade
1. Rip fence out of alignment
2. Splitter not aligned with blade
3. Feeding stock without rip fence
4. Splitter not in place
5. Dull blade
6. Letting go of material before it is
past blade
7. Anti-kick back plates dull
1. Align rip fence with miter slot
2. Align splitter with blade
3. Install and use rip fence
4. Install and use splitter (with guard)
5. Replace blade
6. Push material all the way past blade
before releasing work
7. Replace or sharpen anti-kick back
plates
Blade does not raise or tilt
freely
1. Too much tension in raising
mechanism
2. Sawdust and debris in raising and
tilting mechanisms
1. Adjust raising worm and arbor bracket
2. Clean and regrease