TOUGH-WORKS TDS-G200VLDB, Инструкция по эксплуатации

Страница: 11 / 20

11
ASSEMBL
Y INSTR
UCTIONS
WARNING
!
position. See Figure H.
3. The eye shields should be positioned over
the wheels to protect the user against any
sparks or debris that may be thrown during
use.
4. Adjust the eye shield bracket and eye shield
into the desired position above the grinding
wheel, then tighten the knobs.
ALWAYS USE THE EYE SHIELDS AND WHEEL
GUARDS provided with the grinder.
FIG. H
WORK LIGHT
The Bench Grinder is provided with a Flexible
Work Light to assist in visibility of the workpiece.
To reduce the risk of fire, use a 120 volt, 40 Watt
or less Track Light Bulb, Type R20, medium
base or equivalent (included).
DO NOT use a light bulb that extends past the
end of the light housing.
The Flexible Work Light housing will remain hot
for a few minutes after turning it “OFF”. Avoid
contact with housing until it is cool.
WARNING
!
PERMANENT MOUNTING (Fig. I)
Use the mounting holes in the base of the grinder
to firmly attach grinder to a solid work surface
or grinder stand (mounting hardware and stand
not included). See Figure I.
To avoid serious injury, secure the Bench Grinder
to a solid work surface. If the Grinder is not
permanently mounted to a work surface, and
remains portable, the Grinder’s base should
be temporarily clamped to a table or board/
plywood. Make sure that the clamps do not
interfere with the tool rests, wheels or hinders
the movement of the user and the material
being ground during use.
If the Bench Grinder is not securely mounted,
it will have the ability to move or tip over during
grinding operations and possibly cause the
operator’s fingers to contact the grinding wheels.
FIG. I
WARNING
!
ALWAYS WEAR EYE PROTECTION!
Everyday eyeglasses are NOT safety glasses.
ALWAYS wear Safety Goggles (that comply
with ANSI standard Z87.1) when operating
power tools.
Hot sparks and debris are produced during
grinding and wire wheel operations. Wearing
a respirator or dust mask is recommended.
CAUTION
!
TDS-G200VLDB
USING THE WHEEL DRESSER (Fig. J)
The Wheel Dresser is to be used to remove any
forward wobble, buildup up of material on the
grinding wheel, remove imperfections, and make
the corners of the grinding wheel square. See
Figure J.