Main
component
Cap nut
Upper installation fitting Lower installation fitting
Caps
Screws
Screw it in
Screws
Hexagon
wrench
（Large）
Hexagon
wrench
（Large）
Installation Procedure
4
-2
Install the Installation Fitting
Hole for
upper
installation
fitting
Coach screw
Spring washer
Washer
Coach
Screw
Spring
Washer
Washer
Upper installation
fitting
Lower
installation
fitting
Hole for
lower
installation
fitting
Foamed Gasket
Foamed
Gasket
①Peel off the paper on the foamed gasket and stick
the paper on upper and lower installation fitting.
②When you install the installation fitting,
be sure to orient it correctly.
The coach screws
should be more fixed
than the installation
fitting.
Peel-off
Paper
Peel-off paper
5
Install the showerhead
Projection on the
Main component
Groove of the
Installation
Fitting
Upper
installation
fitting
Screw it in
Attach Here
Lower
installation
fitting
Protective
Material
Installation
Legs
Side connections part
of the main component
While attaching, be careful
not to damage the O rings
of the installation legs.
O. ring
6
Attach the Main Component
Caution
When you install showerhead,
please do not cut or scratch
the o-ring.
For easier and more effective
installation, lie down the Shower
Tower main body and install the
showerhead.
Main component
Main component
①Remove two caps of installation leg.
②Fit the fitting in the groove at the
projection on the top of the main
component,
③Remove the protecting material, use
the capnut for the side connection
part of the main component to attach
the installation legs well.
④Attach the main component to the
installation with the screws.
※While attaching it, adjust the
installation fitting so that there is no
clearance between the main
component and the installation fitting.
⑤Install the coach screw for the
installation fitting and tighten it so
that it is stable.
Shower Arm
O-Ring Seal Area
Hole/water line
Shower Arm
Showerhead
Stopper
<Top View>
Screws
Hexagon wrench
(Large)
①Align stopper on Showerhead
with the water line on Shower
Arm.
②Insert Showerhead all the way
into Shower Arm, then turn 45
to align screw holes.
③Use Hexagon Wrench to install
the screws onto the Shower
Arm.
Adjust after installation
1.Confirm water can flow out
3.Ajust flow rate
2.Clean the filter first
Use screws to install the covers
on the main component.
then install the right
lower cover
Upper
cover
Screws
Upper
cover
Screws
Lower
cover
Screw
Screw
Lower
cover
Hexagan wrench
（Small）
8
7
9
Caution
Caution
Installation Procedure
Install the Shower Hanger
Install the Shower Hose
Install the Covers
Please install after
the filter is cleaned
Screws
Shower Hanger
Use screws to install the shower hanger to the main component
by hexagan wrench.
Be sure to orient the
shower hanger correctly
Check the gasket insaide
①Use your hand to turn the shower hose
into the connection part of the
main component.
②Place the hand shower on the shower
hanger
Hand Shower
Gasket
Shower hose
Shower Hanger
4/6
See next page
