60
Before Installing
●If the water supply pressure is higher than 0.75MPa, you should
buy a reducing valve to reduce the pressure by 0.2-0.3MPa.
To use the shower faucet comfortably, a pressure of about
0.2-0.3MPa is recommended.
●To prevent being scalding due to malfunction, the water supply
pressure must be higher than the hot water pressure, or at
least equal.
Also, when you increase the pressure of the hot water side, it
must remain lower than the water supply side.
●You may find residual water in the product. This is due to testing
by feeding water through the product before packaging,
this is not a problem.
●To reduce resistance, the pipe that is connected to the hot water
device should be as short as possible, and the pipe should be
wrapped with insulating material.
●To prevent being scalded due to malfunction, a hot water supply
temperature of 60℃ is recommended.
●The hot water supply temperature should be set 10℃ higher than
the intended temperature during use.
●Confirm that the wall supporting the shower tower is strong enough.
●Please choose the fixation method that is appropriate for the
structure of the building.
●In case of install on the wall of concrete substrate, please use the
plastic plug in the package.
86.5
(2000)
1375.5
60
95
95
620.5
(1088)
(711)
474
604
104
40
485
80±10
(833)
(969)
Set-up Drawing
※Some models may have different components as illustrated below.
Dimensions in parentheses are for reference.
Please install it to adjust height of users.
Plastic plug（3pcs）
Do not remove the
masking film before
finishing installation.
Do not take hold on
the temperature
-adjusting handle
while carrying.
2/6
See next page
Components
Confirm that you have the following parts.
Metal Fittings for Installation
Screws (11 pcs)
Shower Tower Main Component
Main component
Parts for the Hand Shower
Parts for the Overhead Shower
Others
※ Your parts may be different depending on the model.
Parts for installation legs
Gasket
Hand shower
Shower hanger
Screws (2 pcs)
Lower installation fitting
Upper installation fitting
Coach screws (3pcs)
Foamed gaskets (3 pcs)
Washers (3pcs)
Spring washers (3pcs)
Protective
material
Screws（4pcs）
Hexagon wrench
4mm
2.5mm
Open/shut tool
Contruction tool
Installation Manual
Owner s Manual
Protect caps(2 pcs）
Installation screws
(2 pcs)
Shower head
Do not remove the
masking film before
finishing installation.
Do not put main
component against
the wall.
Lower covers
Upper covers
Please give away
to customer.
Installation legs
(2 pcs)
