Before Installing Your TOTO Soap Dispenser
1. Wiring
The voltage is AC 120V (60Hz). The energy consumption is as follows.
Wiring should be installed in compliance with the following energy consumption levels.
10W
20W
30W
Single spout configuration : TES1ADC-05
Two spout configuration : TES2ADC-05
Three spout configuration : TES3ADC-05/TES3ADC-12
Four spout configuration : TES4ADC-12
40W (20W+20W)
Five spout configuration : TES5ADC-12
50W (20W+30W)
Six spout configuration : TES6ADC-12
60W (30W+30W)
2. Installation of the soap tank
3. Other
Install the soap tank and sub-tank (Special) on a flat surface.
When connecting the tank or installing the sub-tank (Special), make sure that both tanks are in-
stalled on a flat and level surface. Be sure to install the soap tubes in a straight line.
This product cannot be used with stainless steal or stainless steal plated lavatories, as this may
cause malfunction of the product.
The dispenser installation holes for this product are 1"~ 1-1/8" (25 ~ 28 mm) in diameter.
Be especially careful not to scratch the sensor surface.
