Trial Operation
(1)
(2)
Caution
1. Confirming that the dispenser functions properly after installation
After installation is complete, confirm that the unit is working properly using the following method.
Place your hands under the dispenser spout and hold them in place until soap is discharged.
Make sure that there is no soap leaking from the tube and hose connections.
The dispenser pump will operate intermittently. After
the third discharge, the dispenser will operate contin-
uously for a maximum of 4 minutes.
Continuous discharge only takes place within 15 min-
utes following power ON.
2. When the dispenser is not in use for long periods of time
If the dispenser is not in use for an extended period of time, the liquid soap in the tube may
water
dry up and clog the tube. In such a case, fill the dispenser tank with
and perform a tri-
al operation. Once you have confirmed that the dispenser is working properly, replace the
water in the tank with liquid soap.
3. Confirming proper operation
Starting and stopping the soap discharge.
Hold your hands under the dispenser spout to automatically discharge soap foam.
Remove your hands from under the spout and the dispenser will stop pumping soap.
Hold your hands under the spout continuously and an intermittent discharge of soap is pumped (a maxi-
mum of 3 discharges over a two-second period).
4. Trouble shoting
Phenomenon
What to look for
What to do
Reference page
No soap
comes out.
It doesn't
dispense
mousse.
Hardly
any soap
comes out.
7
8
,
4
5
,
4
5
,
4
5
2
Is the AC adapter inserted in the electrical outlet? The AC adapter is inserted.
Fill the tank with liquid soap.
Insert tube.
Insert the white connector.
Remove the knik.
Insert the green connector.
Please use the recomme-
nded liquid soap.
Insert the blue air tube all
the way into place
Instruction manual
Does the liquid soap tank contain liquid soap?
Is the soap tube inserted securely?
Is the white connector inserted securely?
Is there a kink in the tube?
Is the green connector for the air pump inserted securely?
Are you using a high-viscosity liquid soap?
Is the blue air tube pushed all the way into place?
A bent hose is corrected.
Hasn't the connected hose of the sub tank and
the water soap tank bent?
