Toto G400 SN920M, Инструкция по эксплуатации

Страница: 56 / 64

56
Flushing
Trouble Please check
Ref.
Page
For not fl ushing
●
Is the shutoff valve fully open?
15
●
Has a power outage occurred?
➞
You can flush the toilet with the hand lever (for flushing in case of power
outage).
50
●
Has a water failure occurred?
➞
Use a bucket to flush water.
50
●
Are all LEDs on the main display fl ashing?
➞
Disconnect the power plug and insert it again.
If the same symptom reappears
➞ There may be a malfunction. Consult
with the contact referred on the back cover of this manual.
54
The toilet does not
fl ush even when the
button is pressed
●
Are you pressing the button repeatedly?
(After the toilet
fl ush button is pressed, it becomes inactive for at least about
20 seconds.)
●
Is the LEDs on the main display fl ashing?
 
The tank is fi lling with water. (This takes about 60 seconds maximum.)
-
The bowl unit
does not clean
automatically
or timing is delayed
(Auto bowl
unit cleaning)
● Is "AUTO FLUSH" set to "OFF"? ➞ Set to "ON".
● Even if "AUTO FLUSH" is set to "ON", it is not available in the following instances.
  60 seconds after the toilet is fl ushed. ➞ After 60 seconds have passed,
fl ush using the remote control.
  When the amount of time seated on toilet seat is about six seconds or less.
➞ Flush with the remote control.
  When staying in front of the bowl unit after standing and using the toilet
➞ Stay about 30 cm (about 0.98 ft) or more off the bowl unit and wait about
3 seconds.
  When water droplets or dirt are disrupting the body sensor.
➞ Remove the dirt.
● The seat switch will not turn on unless you sit on the seat properly.
➞ Sit back on the toilet seat.
38
16
16
-
12
11
●
The timing for the auto bowl unit cleaning can be changed.
(After about 10 seconds
➞
after about 5 or 15 seconds)
38
The toilet fl ushes on
its own
●
Is "AUTO FLUSH" set to "ON"? ➞ You can turn it "OFF".
●
Does the seat switch or the body sensor have dif fi culty turning on or detecting?
➞
Sit back on the toilet seat. If you lift your hip off the toilet seat during use
or sit forward on it, the seat switch may not turn on, and thus auto flushing
may occur during use.
➞
Remove any dirt that is on the body sensor.
38
9
10
Troubleshooting
Warm air drying
Trouble Please check
Ref.
Page
The dryer
temperature is low
●
Is the dryer temperature set to low level?
22
Stops in the middle
of use
●
The feature stops automatically after 10 minutes of continuous use.
●
Does the seat switch have dif fi culty detecting?
➞
Sit back on the toilet seat. If you get up slightly from the seat, or sit forward on
the seat, the seating switch may temporarily stop detecting your presence.
-
11