Toto 0GU5020, Инструкция по установке и эксплуатации

Страница: 3 / 12

3
ENGLISH
INSTALLATION PROCEDURE
1) Unscrew the bolt on the drain piece. Remove the drain grate and gasket from
the finished parts bag. Add the plumber’s putty and install the drain as shown.
N OTE: Make sure that the bath tub floor and drain hole are clean and free of
burrs and debris. Make sure the gasket under the drain grill is present and
flat, not twisted. Remove any excess putty from around the drain.
2) Remove the center nut from the overflow. Remove the overflow grate. Place
the overflow on the outside of the bath and the overflow grate on the inside
of the bath and re-tighten with the nut. Hand-tighten the nut plus a quarter
turn with a wrench.
N OTE: Make sure the gasket is present and undamaged.
3) Test fit the T-connection onto the pipes to test the length. The pipe should
extend at least 1” (25 mm) into the connection. If it is too long, cut the pipe
to fit. Clean the cut edge with a sharp knife.
N OTE: The T-junction may be installed for standard (vertical) or above floor
(horizontal) exit. For above floor (horizontal) exit, be sure to add an angle
(incline) to assure that the water flows away from the bath.
Gasket
Bath Tub Wall
Nut
Overflow
Grate
T-Junction
Bolt
Gasket
Drain Grate
Bath
Floor
Add plumber’s
putty here
4) Insert the pipes into the connection and tighten the nuts by hand. Tighten
the nuts one quarter turn with a wrench.
N OTE: Make sure the cone washer is aligned correctly, with it tapered
towards the T-connection. Joints may be made more secure by using
plumber’s putty.
Nut
Cone Washer
T-Connection
Cone Washer
Nut
5) Align the screw on the drain handle with the flat spot (or indention) on the
spud.
Tighten the screw with a small Philips head screwdriver.
Flat Spot
(Indention)
6) Insert drain cover into drain.
N OTE: The screw at the bottom of the cover can be adjusted to give the
cover the proper height.