7
LCD Panel Cleaning
When cleaning the LCD Panel it is very important to use non-abrasive and
ammonia free cleaning agents and a clean micro fiber clothe, or cheese clothe. Do
not use paper towels. Paper towel fibers are coarse and may scratch the surface
of the LCD screen. Paper towels may also leave streaks on the surface.
Antistatic and fingerprint resistant cleaning agents are recommended.
Operational Setup
1. Unpack the LCD-703HD and accompanying remote control.
Physically inspect for any damage that may have occurred during shipping.
Should there be any damage, immediately contact ToteVision at 206-623-6000.
2. Connect required cables for signal input and output.
Please note that power must be applied to the LCD-703HD for the S-Video
outputs to be activated. All BNC connectors should be rated for 75
Ω
.
3. Plug the power supply into the A.C. source.
Please note that power can be supplied from a variety of DC sources, such as
batteries or Vehicle power. Input power range is 5.0 to 20 Volt D.C.
In operation, the LCD-703HD will draw approx. 0.4 amp. @ 12VDC.
4. Turn on the LCD-703HD by tapping the power switch located on the front of
the unit.
5. LED indicate selected signal source. It becomes bright if there is video loss.
9
Input Connectors
* Composite Video Inputs comply to SMPTE-170M
* Component Inputs comply to ITU-BT.601/656
* BNC Output always active regardless of Power ON/OFF
* S-Video Outputs active when power is ON.
