At the thermostat, select the mode (Auto,
Heat Cool, or Off).
Adjust the setpoints to the desired settings.
Here, at the base station, press the
corresponding button for 10
seconds. The LED will flash for
5 minutes
Within 5 minutes of pressing
the button on the base station,
press the link button on the receiver for 3 seconds. The LED on
the receiver will flash twice.
The base station will now remember your settings. You may
change these settings at anytime by repeating the above
steps.
Refer to owner’s manual for more details
1
1 4
4 77
RINGS
11
22
33
44
Energy
Comfort
9vAC Power
LINE
Side View
FAN
OUTSIDE HUMIDITY PROGRAM
VACATION
SET
CLOCK
MODE
Installation & Setup
Page 7
At the Base Station, press the Comfort Settings link button for five seconds.
The green power LED next to the button will turn red and flash for
up to five minutes.
Go to the thermostat, making sure that it is still set to your Comfort Settings.
Within five minutes of pressing the link button on the Base Station, press the
link button on the side of the RF Wireless Module for three seconds. The
LED on the RF Wireless Module will flash indicating the following:
2 flashes indicates that the link was successful
5 flashes indicates the communication was good, but the
thermostat was not in the appropriate mode; only
Auto, Heat and Cool are supported
10 flashes indicates a communication problem
After two flashes on the RF Wireless Module, the Base Station will remember
your Comfort Settings. You may change these settings at anytime by
repeating the above steps.
Link Button
LED
44
33
33
44
PROGRAM
VACATION
SET
CLOCK
MODE
HUMIDITY
OUTSIDE
FAN
ANSWER MACH.,
FAX, OR PHONE
