At the thermostat, select the mode (Auto,
Heat Cool, or Off).
Adjust the setpoints to the desired settings.
Here, at the base station, p ress the
corresponding button for 10
seconds. The L ED will flash fo r
5 m inutes
Within 5 minutes of pressing
the button on the base station,
press the link button on the receiver for 3 seconds. The LED on
the receiver will flash twice.
The base station will now remember your settings. You may
change these settings at anytime by repeating the above
steps.
Refer to owner’s manual for more details
1
1 4
4 77
RINGS
11
22
33
44
Energy
Comfort
9vAC Power
LINE
Page 11
Press and hold the same desired link button for another five seconds. When the LED
begins flashing rapidly, release the link button.
Press and hold the link button on the RF Wireless Module for three seconds. The RF
Wireless Module’s flashing LED will indicate the status:
2 flashes indicate the unlink was successful.
10 flashes indicate a communication problem or the RF Wireless Module was not
linked to the Base Station.
Press the desired link button (Comfort or Energy) for five seconds. When the LED
begins flashing red, release the link button.
Installation & Setup
Notes on the unlinking procedure
After the unlinking process is complete, the Base Station’s LED stops flashing
The unlink mode remains active for five minutes
The unlinking procedure may be cancelled by pressing the Base Station’s link button
(Comfort or Energy) while its LED is flashing red
Side View
FAN
OUTSIDE HUMIDITY PROGRAM
VACATION
SET
CLOCK
MODE
If it becomes necessary to unlink the thermostat(s) from the Base Station,
follow these steps:
ANSWER MACH.,
FAX, OR PHONE
