Total TS730301, Руководство пользователя

Страница: 5 / 18

Caveat
Exposure to excessive noise levels can result in permanent hearing loss. Always wear
proper hearing protection, such as safety ear muffs or safety ear plugs. This will reduce
noise levels when using the band saw.
Additional safety instructions for the band saw
•
To avoid injury from unexpected movement, make sure the saw is on a firm, level
surface and is properly secured to prevent it from rocking. Make sure there is
enough space for operations. Bolt the saw to a supporting surface to prevent
slipping or sliding during operation.
•
Turn off and unplug the saw before moving it.
• Use the correct size and type of blade.
•
Make sure the teeth of the saw blade point down and toward the table.
•
The saw blade guide, brackets, bearings, and blade tension must be properly
adjusted to prevent accidental contact with the blade and minimize blade
breakage. To maximize blade support, always adjust the upper blade guide and
blade guard so that it just clears the workpiece.
•
The table lock handle must be tight.
• Use caution with very large, very small, or awkward workpieces.
•
Use additional supports to prevent workpieces from slipping off the table surface.
Never use another person in place of a table extension, or to provide additional
support for the workpiece.
• Work pieces must be secured so they do not twist, swing, or slip while being cut.
•
Plan small or complex jobs carefully to avoid pinching the blade. Avoid awkward
operations and hand positions to prevent accidental contact with the blade.
•
Small parts must be secured with clamps or accessories. Do not hold small parts
by hand as your fingers could slip under the blade guard.
• Cut only one workpiece at a time. Make sure nothing is on the table except the
workpiece and its fences before turning on the saw.
• Always observe the saw in operation before each use. If there is excessive
vibration or unusual noise, stop immediately. Turn off the saw and unplug it. Do
not restart the saw until the problem has been located and corrected.
•
To release jammed material, turn off the switch. Remove the key from the switch
and unplug the saw. Wait for all moving parts to stop before removing jammed
material.
• Do not leave the work area until all moving parts have stopped. Disconnect power
from master switches. Remove the switch key from the band saw and store it in
a safe place out of the reach of children.
Indications for the use of extension cables
In the event of a malfunction or breakdown, grounding provides the path of least
resistance for an electrical current and reduces the risk of electrical shock.
This tool is equipped with a power cord having an equipment-grounding conductor and
a grounding plug. The plug must be plugged into a matching outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
• It must be grounded while in use to protect the operator from electrical shock.
•
Do not modify the supplied plug. If it will not fit into the outlet, have a licensed
electrician install the proper type of outlet.
• Improper connection of the equipment grounding conductor can result in a risk of
electric shock. The green insulated conductor (with or without yellow stripes) is
the equipment grounding conductor. If it is necessary to repair or replace the