Total TS730301, Руководство пользователя

Страница: 10 / 18

•
Loosen the front blade guide screw to adjust the front blade guard.
•
Attach the front blade guard and retighten the front blade guide screw.
• Secure the table in position with the adjusting screw (5) and the table tilt lock
lever (6).
• Using a combination square, set the table perpendicular to the blade. Adjust the
table tilt lock lever if necessary.
• Set angular guide pointer to 00.
•
Insert and tighten the bolt and wing nut into the hole located in the front edge of
the table.
Install Variable Guide (FIG.6)
• Raise the variable fence clamp to the up position.
•
Place the fence on the table so that the clamp is at the front of the table.
•
Lower the fence clamp to lock the fence in position on the table.
Note: To move the variable guide, lift the clamp and slide the guide to the desired location. Lower
the clamp to lock the fence in position.
Caveat
Never use the miter gauge and rip fence at the same time. The blade could get stuck in
the work piece. The operator could be injured and/or the workpiece could be damaged.
Settings
Caveat
Before adjusting the band saw, turn off the saw, remove the safety key, and unplug the
power cord from the electrical outlet.
Table tilt adjustment (FIG.7)
The table tilts from 0° to 45° to the right.
•
Turn the table tilt lock lever counterclockwise.
• Turn the screw to adjust the table tilt until the pointer is at the desired angle on
the table tilt gauge.
wing nut
Table tilt lock lever
guide clamp
variable