Total TG501032, Руководство пользователя

Страница: 7 / 10

7
Maintenance and cleaning
Maintenance
Make sure the tool is unplugged from power before performing any maintenance.
Replacement of carbon brushes
Carbon brushes must be checked periodically. There are two brushes on the tool and
they must be replaced in pairs.
•
Remove the carbon brush holders with a small flat blade screwdriver and check
the brushes.
• If the brush length is less than 6mm, please replace both brushes, let the machine
run without load for 15 minutes. Use only the correct type of carbon brushes.
Note: There is no replacement brush with this tool, if needed, please call the help line.
Cleaning
Periodically clean the ventilation slots. Use only mild
soap and a damp cloth to clean the tool.
Many household cleaners contain chemicals that can
seriously damage plastic. Do not use gasoline,
turpentine, lacquer, paint thinners, or similar products
on any part of the tool.
Do not put any liquid inside the tool and never immerse
any part of the tool in liquid.
Use of accessories
The chart below lists the description, speed of use, and range of some of the small items
supplied with the tool by category. To achieve the best performance of the tool, it is
strongly recommended that you read it before operation; if you do not adhere to this, the
accessories may fail.
Note: Always wear eye protection, insert shaft fully into collet. Use only up to the speeds listed
below.