Total TG1101256E, Руководство по эксплуатации

Страница: 8 / 13

8
Set up
Mounting
Auxiliary Handle Installation
The auxiliary handle can be positioned
in both gearbox positions.
If you are right-handed, adjust the
handle as shown in the figure. If you are
left-handed, adjust the handle in the
opposite direction. When using a cut-off
wheel, you can screw the handle onto
the top of the gearbox.
NOTE: This handle should be used at all
times to maintain full control of the tool.
Blade guard adjustment
Adjust the guard to protect your hands and to control the orientation of the sander debris.
•
Loosen the screw.
• Position the guard at the desired angle.
•
Tighten the screw.
Attention
Make sure the guard is in place before starting the grinder. Never use it without the blade
guard.
Mounting the discs
Place the grinding / cutting disc on top of the inner flange and over the spindle. Make
sure it is firmly seated on the raised section of the inner flange.
Place the outer flange over the blade, making sure the raised side is facing the blade
and that it is fully seated in the center hole of the blade.
NOTE: When clamping thin section metal diamond blades, the outer flange must be reversed so
that the flat / concave side screws against the blade hub.
Press and hold the spindle lock button and tighten the outer flange with the two pin push
wrench. It may be necessary to rotate the spindle to fully locate the spindle lock button.
Screw