Total TG1101256E, Руководство по эксплуатации

Страница: 10 / 13

10
For better tool control, material removal and minimal overload, maintain an angle
between the blade and the work surface of approximately 15 ° -30 ° during grinding and
10 ° -15 ° during sanding. Put light pressure on the abrasive discs for efficient operation.
Pushing too hard will cause a drop in speed and can lead to overloading and motor
damage.
Be careful when working in corners, as contact with the intersecting surface can cause
the tool to jump or twist. When grinding is complete, allow workpiece to cool. Do not
touch the hot surface.
Overload
Overloading will cause damage to your tool's motor. This can happen if it is subjected to
heavy use for long periods of time. In no case try to exert too much pressure on your
angle sander to speed up your work.
Abrasive discs work most efficiently when light pressure is exerted, thus avoiding a drop
in speed. If your tool gets too hot, run it without load for 2-3 minutes until it has cooled
down to normal operating temperature.
Job tips
• His tool is useful both for cutting metals; for example, to remove screw heads, as
well as to clean / prepare surfaces; for example, before and after welding
operations.
•
Different types of disc / cutter will allow the sander to meet various needs.
Grinding wheels / cutting wheels are typically available for mild steel, stainless
steel, stone, and brick. Diamond impregnated discs are available for very hard
materials.
•
If the grinder is used on soft metals such as aluminum, the disc may bind and will
need to be replaced.
•
At all times, let the sander do the work, do not force it or apply excessive pressure
to the discs.
•
If a slot is cut, make sure the cutter stays aligned with the slot, twisting the cutter
may cause the blade to break. If cutting a thin sheet, just allow the cutter to
protrude from the material, excessive penetration can increase the possibility of
causing damage.
•
In the case of cutting stone or brick, it is recommended to use a dust extractor.
The electronic control allows a continuous preselection of the speed according to
the material to be worked. Constant electronic control keeps the preset impact
rate nearly constant between no-load and load conditions.