Total TG1091156, Руководство пользователя

Страница: 8 / 13

8
Set up
Mounting
Installation of the auxiliary handle
The auxiliary handle can be placed in
both positions of the gearbox.
If you are right-handed, adjust the
handle as shown in the figure. If you are
left-handed, adjust the handle in the
opposite direction. When using a cut-off
wheel, you can screw the handle to the
top of the gearbox.
NOTE: This handle must be used at all times
to maintain full control of the tool.
Blade Guard Adjustment
Adjust the guard to protect your hands and to control the orientation of sander debris.
•
Loosen the screw.
• Position the protector at the desired angle.
•
Tighten the screw.
Attention
Make sure the guard is in place before starting the grinder. Never use it without the blade
protector.
Mounting of the discs
Place the grinding/cutting wheel on top of the inner flange and over the spindle. Make
sure it is firmly seated on the raised section of the inner flange.
Place the outer flange over the disc, making sure that the raised side is facing towards
the disc and that it is fully seated in the center hole of the disc.
NOTE: When clamping thin section metal diamond blades, the outer flange must be reversed so
that the flat/concave side bolts against the hub of the blade.
Press and hold the spindle lock button and tighten the outer flange with the two-prong
torque wrench. It may be necessary to rotate the spindle to fully locate the spindle lock
button.
Screw