STEP • 12
STEP •13
07
= Drill Points using
screws provided as shown
x2
4.0 x 70mm
Per Floor Section
x3
x3
4.0 x 38mm
CORNER STRIPS
SIDE & CORNER STRIPS
Hide the panel edges.
Cover the framework &
seams.
12a.
Use all the side/corner strips to finish
off the shed, by covering any exposed
framework and the panel joining seams.
INFORMATION
The Corner Strips cover all panel edges.
Remember to attach these to the exterior back
panels too.
= Drill Points using
screws provided as shown
x2
4.0 x 70mm
Per Floor Section
x3
x4
4.0 x 70mm
Per Roof Panel
APEX ROOF PANELS
APEX ROOF PANELS
Place 6ft Roof section.
Repeat for all Roof Panels
13a.
Place the 6ft x 4ft roof section
in place. Repeat this stage for models
as shown below. Repeat placing the
roof panels corresponding to the
panel size for the Floor Front
an Rear.
INFORMATION
The Roof Panels are placed ontop of the
appropriate front Panel, making sure that the
sizes corrispond correcly.
13b
13b.
Screw the roof panel
down as shown in
diagram 13b.
Repeat
this for all roof panels, making
sure each panel is sitting on its
corresponding sized
front/back panel.
© Sheds (Midlands) Limited 2021
www.totalsheds.co.uk
