8
ELEVATE
®
PRESS
TM
OWNER’S GUIDE
ASSEMBLY / START
GETTING
STARTED
As a facility offering the use of a
ELEVATE Press to customers, or as
a personal user of the product, you
(as owner of the product), assume
the responsibility to become familiar
with the guidelines relative to safe use
of the product and to convey these
guidelines to all users. Read all safety,
warnings and usage instructions
before using the ELEVATE Press. Care
and maintenance for this product are
included to promote safe, enjoyable
and prolonged use of this equipment.
When using your ELEVATE Press,
wear athletic shoes and comfortable
lightweight clothing. Before you begin,
check to ensure that all parts are in
place and working properly. Remember
to control the glideboard at all times,
particularly when getting on or off your
ELEVATE Press.
WARNING
Always control the glideboard
while using your Total Gym
ELEVATE Press.
ELEVATE Press is rated at a
maximum user weight capacity
of 400 lbs [181 kg].
STEP 8.
Attach
B
to
A
as shown. Using
the 5 mm Hex Wrench install all eight
Short M8 screws with washers. Do not
tighten completely until all eight screws
have been installed.
D
STEP 9.
Now that you have assembled
A
and
B
to create
D
as shown in
STEP
8
, you will need to take
D
and lay it over
the top of
C
. Be sure to place a cloth or
packing material between the surfaces.
Place cloth or packing
materials here
Hinges
Using the 5 mm Hex Wrench, attach the
hinges on to
C
assembly with four Long
M8 screws and washers. Do not tighten
any completely until all four screws are
installed.
STEP 10.
While one person holds the
Incline Strut up as shown, the other
person aligns the hinges to the set of
holes in the rails. Match the letters at each
hole to the corresponding letters on the
strut so that you know you are connecting
the two pieces correctly, and using the
5 mm Hex Wrench install the screws.
Do not tighten any completely until all
four screws are installed.
Placard
Plate
STEP 11.
Turn the unit right-side up
and position your ELEVATE Press in a
permanent location then bolt to floor from
the Anchor Feet as shown below.
BOLTS
NOT INCLUDED.
Bolt to floor from Anchor Feet
Содержание ELEVATE PRESS
Страница 1: ...ELEVATE PRESS TM OWNER S GUIDE...
