Page 12 of 16
FL TUB
Revision:
1
/
26
/201
8
HAND-HELD SHOWER OPERATION
:
1. With the water on, push the diverter button down. Water will be diverted from the spout to the hand-held shower.
2. To adjust the spray setting, turn the control ring located on the outer edge of the shower head.
3. To divert the water back to the spout, simply turn off the water supply. When you turn the water back on, the water
will automatically flow out of the spout.
HYDROTHERAPY SYSTEM OPERATION
:
1.
To operate the
Air Massage System
with the 3-speed variable motor,
push the button labeled
AIR
to turn
on the
system. It automatically starts at the highest setting. Push it again for the medium setting. The third
push
is the low setting. The fourth push will shut off the system.
•
Jets run for 20 minutes then automatically shut off.
•
Blower is equipped with purging/drying cycle that will start 20 minutes after use and will continue
for several minutes.
2.
To operate the
Whirlpool System
, push the button labeled
W
ATER
to turn the system on. Push the
button again to turn the whirlpool system off.
•
Ensure the water level is above all the jets for the jets to function correctly.
•
Damage to the jets and pump can occur if you attempt to operate the whirlpool system without
water.
•
The heat exchanger automatically maintains your water temperature when your whirlpool system
is
operating.
•
Water will drain out of the whirlpool system after each use.
3.
The
Ozone Sanitation System
works automatically with your Whirlpool System.
•
Ozone gas introduced into the water helps to sanitize your whirlpool system from material such as
soaps and body oils that may be found in your bath water and plumbing.
•
When your Whirlpool pump is on, the system immediately generates ozone gas that is mixed in
with your circulating bathwater.
•
When the Whirlpool pump is turned off, the ozone system automatically turns off.
4.
Operating your
Bidet Jet
for personal hygiene
:
•
Turn on your
whirlpool system
by pushing the button labeled
WATER
.
•
Turn the knob labeled
BIDET
counter-clockwise (to the left) to increase the strength of the jet.
•
To decrease the strength, turn the knob clockwise (to the right).
5.
Operating your massaging
Back Hydrotherapy Jets:
•
Turn on your whirlpool system by pushing the button labeled
W
ATER
.
•
Turn the knob labeled
BACK JET
counter-clockwise (to the left) to increase the strength of the
back jets.
•
Turn the knob clockwise (to the right) to decrease the strength of the jets.
